🚙 Conquer every trail with precision power and unstoppable control!
The INJORA MB100-R80 is a 20A brushed mini ESC designed for 1/24 and 1/18 scale RC crawlers, featuring a built-in 6V BEC, IP67 waterproof rating, and advanced protections including low-voltage, overheat, and short circuit. Its linear throttle response and Dynamic Electronic Overload technology deliver smooth, powerful control, compatible with most transmitters like INJORA and Flysky GT5.
Size | V2 |
Material Type | Metal |
Theme | Truck |
Toy Vehicle Form | Crawler |
Supported Battery Types | Lithium-Ion |
Are Batteries Required | No |
Operation Mode | manual |
Power Source | Battery Powered |
Additional Features | Portable |
M**R
Great ESC for SCX24 and Panda Hobby Dodge
I have two SCX24s and an older Panda Hobby Dodge, slow speed control was not good and the escs whined, real bad, especially the Panda Hobby esc. I was thinking of getting rid of the trucks, I have a bunch of 1/18th rigs, but instead found out about this inexpensive drop in replacement esc where you can keep the stock radios and receivers. I didn't want to drop a bunch of money on these rigs replacing so much. The MB100 works well, slow speed control is much better, and it is as quiet as a mouse. Hooking it up is very straight forward, plug your motor into the MB100 esc, plug the supplied cable from the MB100 to the stock esc/receiver channel 2, and finally plug your battery into the MB100 and you are good to go! If nothing works, check to make sure the plugs to and from channel 2 are in the right orientation. The only problem with the MB100 is where to put all of the electronics!!!!!! If you have a SCX24 buy the Injora aluminum side plate at the same time, you can mount the MB100 and battery on the plate or move things around as you wish. Without the side plate, I have electronics high up in the C10 cab, doesn't look cool and throws the weight balance off.Edit: This ESC has breathed new life into my SCX24s, the slow speed control with stock motor is actually really good, it has made it a pleasure to drive these rigs once again. The side plates did not help with placing the electronics in the C10, the MB100 would still not fit with plugs that stick out. To make the esc fit, I trimmed off the forward lip of the battery tray and placed Velcro in the tray. I then mounted the esc as for forward as possible with Velcro and mount the battery side ways, 90 degrees from the original orientation with Velcro also. I am sure it has slightly worse weight distribution now, but it is not obvious and it is worth if for the slow speed control.If you don't want to spend a bunch of money, but want to improve your SCX24 low speed control while using the stock transmitter and radio, get this esc. It is well worth it, I can't praise it enough.
C**.
Awesome 👌
Great esc! Bang for buck is up there with the best. Smooth,Slow crawl ability greatly improved over the stock esc. Only drawback for me was the terminals on the provided wire adapters,terminals are a bit bulky going into the esc. It's mostly because of my application, got the esc mounted on the side of the frame and the body clear but the terminals push against the body and take it off center. Still giving 5 stars because not everyone will have this small issue, some low profile terminals would make this esc even better!
A**R
Great for the price
The media could not be loaded. It's great I bought it for my trx4m, ultimate low speed control, ultra quiet, works perfectly!!!!Definitely a great upgrade part.
J**N
Really good.
I didn't want to drop brushless money on a couple of trail trucks, so I went this route with 180 Pro motors. I have to say, I am impressed. Almost brushless low speed control with plenty of wheel speed when you need it.
S**
Worth it
Nice and quiet, runs smooth, nice control. Fit in my scx24 deadbolt with just a little trim on the stock mount plate
T**N
Nice little esc
Worked really good in my 1/18 tempest
M**E
Great improvement.
easy to install. replaced the Axial esc on a scx 24 C-10. It had significant stall when rock crawling. It has Injora upgraded axles with faster front drive and the larger Injora brushed motor. The new injora esc was like changing to a brushless system. The imporvement was much greater then I expected. Have ordered one for my Axial scx 24 power wagon. Very quiet. I did have to reverse the motor output wires (negative to positive and positive to negative}.
K**R
Worth every penny
This made my day. Just received my Spektrum Firma brushless and installed it on my scx24 only to be so disappointed by how poorly it ran that it went right into the garbage.Purchased this esc and installed it with my original t50 and it works amazingly!!! 5stars all day long for the money. Stop reading and just buy it.I will say the only quirk I had was the motor polarity was reversed. Switching it on the transmitter worked but the forward was still 80% and reverse was 100%, which is backward. I flipped the motor plug around, set the transmitter back to normal and all is well.Also also if you want the shock tower to hold the goods and have a 3d printer it is on thingiverse for free from yours truly.( Roguebydesign )
Trustpilot
1 week ago
5 days ago