Inkbirdplus Plastic Junction Box, IP67 Dustproof&Waterproof DIY Box, Durable Electrical Project Enclosure, 8 x 6 x 4 inch

I purchased this as a project box for an Inkbird PID controller with SSR relay and heat sink. Plenty of real estate inside for wiring and electronics, but not obscenely large. Mounted the PID and three switches on the front, two plugs on the back. Plenty of additional space if I needed to mount more things. Nice quality and the system holding the front and back together works well.

This was suggested to go with the inkbird PID kit.It's a decent housing, and just the right size, with the ssr cooler mounted inside.

Exactly what I needed to use an Inkbird ITC-1000 to replace my Anvil temperature controller. Box is waterproof, sturdy and easy to work with. Great value for the price. I would definitely buy it again if I need a project box

Great Value for this product, and the seller presented excellent customer service.

The media could not be loaded. The Inkbird plastic junction box is a great addition to the Inkbird PID controller. It provides a spacious platform to mount many accessories like a voltage meter, amp meter , on off indicator lights , switched outlets and of course, Inkbird PID controllers. Water tight with a rubber mounted gasket ,4 corner screw hold downs and threaded equipment hold down points inside .

This box worked perfect for my smoker. Thank you

This appeared to be the perfect box for my project, but it didn’t come with any screws or any way to secure the top of the enclosure to the box. Currently unusable.

Well built, fast shipping, good value. Sounds like an Inkbird product to me!I only gave it 4 stars instead of 5 because it's a bit smaller than what I'll need for a barebones BIAB controller but larger than what is needed for a DIY temp controller for fermentation.EDIT: Revised to give it 5 stars after getting feedback from the homebrewtalk community on controller design and also having an Inkbird rep reach out to me about my questions. Great customer service!